UK Vintage Radio Repair and Restoration Powered By Google Custom Search Vintage Radio and TV Service Data

Go Back   UK Vintage Radio Repair and Restoration Discussion Forum > General Vintage Technology > General Vintage Technology Discussions

Notices

General Vintage Technology Discussions For general discussions about vintage radio and other vintage electronics etc.

Closed Thread
 
Thread Tools
Old 16th Oct 2021, 1:20 am   #21
joebog1
Banned
 
Join Date: Jun 2015
Location: Mareeba, North Queensland, Australia
Posts: 2,704
Default Re: Solid vs Stranded

That's another method then Chris! I tend not to order or even look at American sites for stuff to purchase. US mail charges like a herd of cattle in full stampede. I also notice that "most" of that catalogue you showed is sort of specialised with insulation up to 30,000 volts. Might be a tad high for running in a loungeroom Hi-Fi. Probably good power available though!! .

I am still "testing" the usual Asian sites, but so far I have been a bit disappointed. It's very nice wire, but only good for an amp or so. So, useless for heater wiring, I use standard Aussie switchboard wire which is 24/.2 and is available in 10 colours for heater wiring, and most of my HT stuff, but its a tad large to do a full run around the chassis with two wires into say a 7 pin or 9 pin valve base.

Joe
joebog1 is offline  
Old 16th Oct 2021, 11:03 am   #22
David Simpson
Nonode
 
Join Date: Mar 2008
Location: Aberdeen, UK.
Posts: 2,838
Default Re: Solid vs Stranded

Living close to Aberdeen - Europe's Oil Capital, where prior to the downturn, there was an abundance of ex Oil Rig wiring looms in many a reclamation/scrap yard. Hook-up wiring for HV plant, radio & telecomms wiring, co-ax, screened mic/tel wiring, etc. Prior to the massive rise in copper trading prices, yards of off-cuts could be bought for just a few quid. Yep - a lot of fannying about, stripping off layers of PVC outer insulation & internal cellophane & tinned copper or aluminium screening, but well worth it.
Going back on-topic, 1.0 & 1.5mm sq Delta-Enfeild 6242Y FT&E domestic cabling lends itself to stripping down of off-cuts. Ideal for re-wiring ancient crystal sets & 1920's TRF's in the old stiff-wire method which predominated nigh-on a hundred years ago. Such off-cuts can be carefully tinned, or lacquered with a dark varnish, or sheathed with Dave's shoe/bootlace method, for authenticity. Far far cheaper than modern wee retro rolls being sold on the internet.
There is a vast abundance of info on soldering & tinning methods in the Forum's "Search" facility, the internet, and on Youtube demmo's. Rudimentry soldering(pure Pb) was used in those far-off days, but dont confuse it with post WW2 60/40 solder, and the God-awful "lead-free" methods which have become more predominate in recent decades.


Regards, David
David Simpson is offline  
Closed Thread

Thread Tools



All times are GMT +1. The time now is 3:55 pm.


All information and advice on this forum is subject to the WARNING AND DISCLAIMER located at https://www.vintage-radio.net/rules.html.
Failure to heed this warning may result in death or serious injury to yourself and/or others.


Powered by vBulletin®
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright ©2002 - 2023, Paul Stenning.