Re: Dansette HiFi Mk2 smoking amplifier
We are assuming you have replaced the faulty ECL86, or a buzz is all you will get.
The soldering on the new cap needs a tidy up as Lucien noted.
Do a resistance check on the output transformer first, power off of course.
Measure from the Red wire from the rectifier to each pin 3. Then again from the Red wire to each pin 6. The readings should be similar for each pin 3 (100/150 ohms) and again similar for each pin 6. (150/200 ohms ish) I do not have service data so am guessing. Any doubt tell us what they are.
__________________
Never Leave Well Enough Alone...
Last edited by snowman_al; 18th May 2022 at 5:38 pm.
|