View Single Post
Old 5th May 2021, 8:32 pm   #8
Join Date: Jan 2021
Location: Hulst, Netherlands.
Posts: 27
Default Re: New SC/MP II system

Hello Michael, thank you for the clear response and I see you have a lot of plans for the future.
I run my 600 on 4Mhz and never had a character missing up to now. Make sure it is exactly 4Mhz and not the 4 and a bit (don't remember exactly) that MK14 is using.
fbasic is running too on one of my SC/MP's it is a floating point interpreter and is very close to the PET basic without the graphics. You can find all statements and the HEX on Ronald Dekker's DOS4ever page. I did not dig into this interpreter in detail so cannot tell you al lot about it.

Last edited by audiokit; 5th May 2021 at 8:55 pm.
audiokit is offline