Quote:
Originally Posted by cathoderay57
Quote:
Originally Posted by waynej4;1515547,
For the "Bad" amp, I get a reading of 250ohms from the Y terminal. For the "good" amp it is around 6Mohms. Same for the C4 Cap.
|
250 Ohms from Y terminal to chassis is bad. So the next step is to disconnect wires from the rectifier cathode circuit, i.e. Y terminal and then the choke and recheck resistance to chassis. Unless you have misconnected the earth wire to the 32+32uF cap, so make sure that hasn't been done.
Jerry
|
For my clarity:
1. Remove the wire from the Y terminal and measure resistance from Y to chassis?
2. Remove the choke (Y terminal still removed) and measure again from the Y terminal?
Or should it be remove Y terminal and choke and then measure from Y - all in one step?