Quote:
Originally Posted by ms660
It could be that the antenna isn't being connected to the push button unit properly or the RF section of the push button unit isn't being properly connected to the control grid of the mixer (V1) when the wave change switch is set to the Selector position, check that the switch contacts for S5 and S17 are making good contact and that L28 is ok.
For the wire that's disconnected.....where in the circuit does the connected end connect to ?
All the above refs. are as per the Trader service sheet 399.
Lawrence.
|
Thanks Lawrence. I will check the V1 , S5, S17 and L28 .
To be honest i don't understand what you mean with the disconnected cable .
The cable starts from the "fidelity, Normal,Bass,Foreign" switch .
I believe it has to do with the "Foreign" position because is the only position where nothing changes when i choose it.