Thread: Ortonview PCB
View Single Post
Old 28th Jun 2021, 12:27 pm   #1
Slothie
Octode
 
Join Date: Apr 2018
Location: Newbury, Berkshire, UK.
Posts: 1,287
Default Ortonview PCB

Well since I've been working on this schematic to make an Ortonview PCB so that I can tinker with the firmware which still has a few minor niggles to work out, I thought I'd put the schematic up here in hopes someone will give it a look over and spot any mistakes/bad decisions/missing things that are likely to be in there. The board is intended to plug into the back of a "Issue VI" board using the signals put on the edge connector by the latest release. I have included the essential 1.5k memory hole filler (with optional battery back up) and an option random noise generator clocked from NADS that can be connected to a sense pin or SIN to make random numbers for all those games people are bound to start writing!

I'm going to try to start work on the actual PCB design next week.
Attached Files
File Type: pdf Ortonview_0_1.pdf (209.0 KB, 214 views)
Slothie is offline