Quote:
Originally Posted by Davecru
I have piggy backed it off my 300 series junction box and using the 300 to dial out everything connects and I can hear dial tone speak hear etc but cannot dial at all, can here the pulses but they are very quiet. It hangs up and picks up ok.
|
Perhaps I could ask the OP to clarify whether this
is saying that a 300-series telephone dials out successfully - in which case I would agree with Mike that this means the problem must be within the 232.
edit: comparing wiring with
diagram N332, it appears that the slate and blue wires of the dial are transposed.
Additionally, looking at
diagram N4300 for interconnection with a bellset, I was incorrect about disconnecting the green wire from T2. It
should be connected. I was a little hasty in my original reply, and it's a while since I last connected up a 232.