OK replaced the smoothing caps then wondere why the resistors off the PY82's were glowing red!
Switched off and for some who knows reason I have connected the 100uF cap the wrong way around so it quickly started to get warm.
OK take two with another bunch of caps and I get the 185 Volt HT on the Avo. Also got full raster.
The HH2 arrived today so I had a think and stuck a piece of wire in the TV ant connector and one in the HH2 and set it to generate a test-card.
Flick the switch EGOR flick the switch! It lives it lives.
OK a bit OTT
Tube seems a bit soft can not really tell wit a noisy signal so have to come up with something better. It tunes channels 1 to 5 OK I have the frame linearity to one end of it's travel at present, and if I turn the brightness up I can see fly-back lines, but as I said I really need to get a better signal in.
So what are the two pin plugs called for the aerial and where can I get some?
I also need to figure out a replacement 200uF/100uF can.
Cheers
Adrian