UK Vintage Radio Repair and Restoration Discussion Forum - View Single Post

Station X · 22nd Jun 2021, 8:39 am

I last had a motor (three phase) rewound in 2016. It wasn't cheap, but I had no choice as the motor was specifically made for a machine tool and no other motor would fit or could be adapted. The local company which did the rewind is still in existence.

It might be worth getting a quote from any rewinders local to the OP.

22nd Jun 2021, 8:39 am	#24
Station X Moderator Join Date: Jan 2003 Location: Ipswich, Suffolk, IP4, UK. Posts: 21,286	Re: Restoring a old table grinder I last had a motor (three phase) rewound in 2016. It wasn't cheap, but I had no choice as the motor was specifically made for a machine tool and no other motor would fit or could be adapted. The local company which did the rewind is still in existence. It might be worth getting a quote from any rewinders local to the OP. __________________ Graham. Forum Moderator Reach for your meter before you reach for your soldering iron.