Re: Dalo Pen replacement
For not too complicated artwork then that's a good way to do it Mr Bungle. I'll purchase some of that Tamiya masking tape and give it a go.
I have before tried something similar using PVC insulation tape overlayed with masking tape which seemed to be OK too but is very dependent on the quality of the tape's adhesive. Some cheap tapes don't stick too well.
Why did I use two tapes? Well I didn't trust the masking tape to be etch resistant so the PVC tape seemed better but that alone was not ideal for marking out the design as it will smear as you progress drawing the lines. A layer of masking tape was then required over the top of the PVC. I used a fine tip standard Bic pen for marking out the design.
Regards,
Symon
|