[IKC2E51R8]

I Found a multimeter and managed to see that on Pin 4 Connector L2 of the CRT Panel should be 163v and it measured at 192volts Pin 1 of this connector should be 163v also according to the schematic but its getting nothing 0v.

thats as far as i got measuring though as my ground probe for my multimeter broke (dont even know how, took a quick bathroom break and when i came back the probe was on the floor detached from the cable) Lesson learned, dont buy a 13 euro multimeter and expect it to last, New multimeter ordered for next day delivery (thank god for RS-Components)

anyways, with Pin for being 192v and pin 1 being 0v what do we reckon is going on?

also forgot to mention in the first post (may not be relevant) but when the BUT11 in the Power supply was cooked it took out two of the bridge rectifier diodes, i replaced all 4 of them anyway just in case.