Quote:
Originally Posted by 1100 man
I see the tube heaters have a fuse (1255 630ma) in parallel with a 1 ohm fusible resistor mounted on the tube base panel.
If the line stage is working and the above fuse is OK, check the tube heaters for continuity. It is possible that there is a difference in the pin connections on the flyback transformer and that the heater winding is not actually connected to where it should be!
|
I might be mistaken here, and possibly confusing this with another Philips chassis, but I seem to think there might have been wire links that needed to be changed depending on which lopt was fitted, ie. the square based version or the round base.
Of course with a compatible type replacement I don't know for sure.
I would need to look more closely at the 'diversity tables' given in the full manual.
It is quite a while since I last looked at one of these sets.