Quote:
Originally Posted by Phantomrose1999
I may have found "a" problem, any expert care to help read this diagram please
I circled the part in red boxes, is this supposed to be shorting both ends with the middle conductor ? such that all 3 are shorted ? I opened every switch to make sure this condition does not happen.
I only have a german service manual which is a bad scan....
Tks
|
It's just the printing, the rest position for the change over pole in the switches you've highlighted is to the right hand contact only, in the manual I've got at1,4 does actually show a very small gap between the left hand contact but not at2,2
The contacts shown in the schematic are shown in their rest positions so far as I can make out.
Lawrence.