[itainthard]

Right, after a few days drying out I spent yesterday winding up the variac to see what happened.

All seemed to go well and after a few hours we were at 230V with no smoke or loud bangs.

However although I can hear the EHT side whining away I have nothing on the screen and no sign of the heater element at the base of the CRT.

Does anybody know the pin configuration for this and or what voltage this should have at it as the service book doesn't help?

I have tried putting a meter across the various used pins once powered down and so I think the heater coil maybe open circuit but I am not sure.

Thanks Joe