View Single Post
Old 13th Feb 2021, 2:33 pm   #3
carlos10
Pentode
 
carlos10's Avatar
 
Join Date: Apr 2007
Location: Sint-eloois-winkel 8880, Belgium.
Posts: 168
Default Re: Kenwood R-1000 Receiver.

well thanks for the reply, the parts are not all in the exploded view,
when i disassembled the unit( chassis heavely coroded with rust one upper side of the vfo)
i set the parts of the analog dial asside with no notes because there was the service manual ,unfortunatly it was less detailled then i was assuming,im not sure if all the parts were still in it, so i think is this way, first the small brass collar, then the spring, the plastic dial and then the allumiumscale on it,and then the brass nut , think something is missing under the brass nut, anyway i get it working somehow , but im sure its not correct.
carlos10 is offline