[OldTechFan96]

Hello,

Learning how to varnish something properly is something I'd like to learn as it would be useful for finishing the odd project and cabinet.

I have a nice hardwood tabletop to practice on which has been stripped of its original finish. The varnish is Wilko's fast drying gloss. I also have a cat bowl holder that would benefit from a few coats.

I have read and watched a lot of guides online but this has added to the confusion. Sometimes I think that the information is contradictory or does not yield the stated results.

I tried a few times earlier in the summer and was disappointed with the results that I was getting. More practice is needed.

The biggest challenge is avoiding brushstrokes and achieving a smooth finish. I know that you need to sand between coats but sometimes I think that too much varnish is coming off.

I am ready to start again with the help of the forum.

Any advice would be much appreciated!