Re: Help needed with - Racal Dana 9081
Results of tests requested;-
Pin 13 - state does change between 0-12v when I press the flick switch. Up /down. Up = 12v, down = 0v.
Same effect voltage wise for spin wheel, clockwise 12v, anticlockwise Ov.
No pulse seen at pin 18 when idle.
Pulses seen at Pin18 when I spin wheel in either direction and flick up / down switch either way. Interesting to observe all this!
Set channel to 5kHz and highest band -yes did see pulse on pin 18 when flicking up down switch.
Was there 37.5kHz on pin 10? I recorded 35 kHz on pin 10.
So does this confirm logic board OK? I have left the 4 pins disconnected in case next set of tests requires the same. Thanks again for helping with this Peter and Paula you certainly know your Racal Danas. 👍
|