Bush RP50.
I've been working on an RP50 for the last few days, it's in exeptional condition apart from a damaged platter mat (being sorted).
The other thing is a missing silver control knob centre, so I wondered if I could make one, so I got an ali can and cut a piece out and carefully made a disc and filed it to the exact size, then hot glued it to a flat headed bolt. I placed this in a drill and spun it up using fine sandpaper working from the outside in, the results are really good. A little heat afterwards releases the disc, fit to the knob, nice job,only took about 30 mins. |
Re: Bush RP50.
This is the kind of resourcefulness that can make all the difference to a project!
Regards, Paul |
All times are GMT +1. The time now is 9:55 pm. |
Powered by vBulletin®
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright ©2002 - 2023, Paul Stenning.