Re: 807 (maybe) amplifier build.
Proper chassis built using 2mm ali sheet given to me by Rob AKA Glowing Anode who doesn't seem to have been on the forum for a while. If you see this Rob, you'll see I'm finally putting the sheet to use. It was a bit of a sod to bend, but I scored the underside of the bend will an angle grinder 2mm cutting disk, then ran a triangle file down the score to debur and put an angle on it.
Feels good to be cracking on with building it, what with having been stuck in the "development" stage for a long time.
Progress pic's....
__________________
Curiosity hasn't killed this cat...so far.
|